Loading ...
Loading ...
Loading ...
22
OPERATION
4. Once activated (indicator light ON), the tractor can be driven
in reverse with the cutting PTO (Blade Engage) Lever in the
engaged (ON) position.
5. Always look down and behind before and while backing to
make sure no children are around. After resuming forward
motion, press the REVERSE CAUTION MODE button to return
to NORMAL MOWING.
6. The REVERSE CAUTION MODE will remain activated until:
• The REVERSE CAUTION MODE button is pressed again.
• The ignition key is pressed or removed.
• The operator leaves the seat.
Engaging the PTO (Blade Engage)(Electric
PTO tractors)
Engaging the PTO (Blade Engage) transfers power to the cutting
deck or other (separately available) attachments. To engage
the PTO:
1. Move the throttle to the FAST position.
2. Pull the PTO (Blade Engage) Switch outward into the engaged
(ON) position. See H in Figure 24 on page 15.
NOTE: When operating the tractor be certain that the throttle is
always in the FAST position. Operating with the throttle at less
than full throttle may lead to premature battery wear and a poor
quality cut.
3. To disengage the PTO (Blade Engage), push the PTO (Blade
Engage) Switch inward to the disengaged (OFF) position.
Engaging the PTO (Blade Engage)(Manual
PTO tractors)
Engaging the PTO (Blade Engage) transfers power to the cutting
deck. To engage the PTO:
1. Move the throttle to the FAST position.
2. Push the PTO (Blade Engage) Lever forward into the engaged
(ON) position. See Figure 28.
Figure 28
NOTE: When operating the tractor be certain that the throttle is
always in the FAST position. Operating with the throttle at less
than full throttle may lead to premature battery wear and a poor
quality cut.
3. To disengage the PTO (Blade Engage), push the PTO (Blade
Engage) Lever forward and to the right, out of the locked
position, then release the lever into the disengaged
(OFF) position.
Mowing
WARNING
To help avoid blade contact or a thrown object injury,
keep bystanders, helpers, children, and pets at least
75 feet (23 meters) from the machine while it is in
operation. Stop machine if anyone enters the area.
WARNING
Make certain the area to be mowed is free of debris,
sticks, stones, wire, or other objects that can be thrown
by the rotating blades.
NOTE: Do not engage the mower deck when lowered in grass.
Premature wear and possible failure of the “V” belt and PTO
clutch will result. Fully raise the deck or move to a non-grassy
area before engaging the mower deck.
• Mow up and down slopes, not across. If mowing a slope, start
at bottom and work upward to ensure turns are made uphill.
• Do not mow at high ground speed, especially if a mulch kit or
grass collector is installed.
• Do not cut the grass too short. Short grass is prone to weed
growth and yellows quickly in dry weather.
• Always operate the tractor with the throttle in the FAST
position while mowing.
• On the first pass, pick a point on the opposite side of the area
to be mowed. Follow the point to maintain a straight line.
• Engage the PTO and move the throttle control or throttle/
choke control to the FAST position.
• Lower the mower deck to the desired height setting.
• For best results it is recommended that the first two laps be
cut with the discharge thrown towards the center. After the
first two laps, reverse the direction to throw the discharge to
the outside for the balance of cutting. This will give a better
appearance to the lawn.
NOTE: The speed of the tractor will affect the quality of the
tractor cut. Mowing at full speed will adversely affect the
cut quality.
• Your tractor is designed to cut normal residential grass of a
height no more than 10” (25 cm). Do not attempt to mow
through unusually tall, dry grass (e.g., pasture) or piles of dry
leaves. Dry grass or leaves may contact the engine exhaust
and/or build up on the tractor.
Loading ...
Loading ...
Loading ...