Loading ...
Loading ...
Loading ...
adjustments to compensate for wear
4,
Check rear bearing in the same manner and adjust as
follows:
a. Loosen nuts just enough to permit the eccentric
screws to turn.
b. Rotate the eccentric screws a partial turn (left or
right) as required to take up looseness.
c. Hold the heads of eccentric screws in the position
established in the preceding step and tighten nuts
on unders,de of carriage. Correct adjustment exists
when you cannot keep the 'bearings from turning.
However, excessive bearing pressure will cause
difficult operation and rapid wear.
d. Install carriage cover.
CARRIAGE
\
'HASHER ASSEMBLY
BEARING
PLAIN WASHER
LOCKWASHER
NUT
ARM LOCK ADJUSTING WHEEL
Arm control lever operates a brake shoe that locks and
releases the arm, and automatically releases the arm index
pin for 0 ° & 45 ° miter settings.
The lock action should feel tight and secure. Considerable
amount of effort must be applied to the lever to lock the
arm.
NOTE: Lever must be in unlocked position while making
adjustment.
If adjustment is required, turn arm lock adjusting wheel
under front of the arm clockwise to tighten, counter-
clockwise to loosen.
TIGHTEN
ARM LOCK
ADJUSTING WHEEL
trouble-shooting
HA VE YOU FOLLOWED ALL SIX STEPS OF
THE ALIGNMENT PROCEDURE? IF YOU
HAVE NOT FOLLOWED THEM IN THEIR
PROPER SEQUENCE, YOU CANNOT
EXPECT A CCURA TE CUTTING RESUL TS.
In addition to the proper alignment of your saw, you underneath workpiece or between workpiece and
must also bocorne familiar with the following practices fence•
_n order to expect the best results. 5. Workpiece must be held tightly against fence and
1. Edge of workp_ece which is placed against fence must down against the table . this is especially important
be as straight as the long side of your framing square, when making angle cuts because the workpiece has a
2. Workpiece must be as flat as the front table board on tendency to move.
your saw. 6. Always use the correct sawblade for the job... Always
3. There must be no sawdust or other wood chips keep it sharp•
between the fence ana the front table board 7 When making a four sided frame:
4. There must be no sawdust or other wood chips a. The two side pieces must be exactly the same length.
3O
Loading ...
Loading ...
Loading ...