Loading ...
Loading ...
Loading ...
5. Move arm and carriage to screw "B" and tighten
support in the same manner.
6. Move arm and carriage to right hand support channel
and level in the same manner you adjusted the left hand
support channel.
7. Recheck both support channels to make sure that
t_ghtening screws did not affect the accuracy of the
adjustment.
8. Elevate saw and place motor in vertical position to
provide clearance for installation of front (work) table.
I J/ TABLE MOUNTING
[ / ....-1 SUPPORTCHANNEL
(LEFT HAND)
/
SCREW "A"
INSTALLATION OF FRONT (WORK) TABLE.
1.
Place front table board upside down on a workbench or
on the floor. Drive T-nut into the hole that is not
co unterbored.
2. Align the counterbored holes with matching holes in
support channels. Install the five 17/64 inch flat
washers, and four 1/4- 20 x 1 inch Pan-Head machine
screws. Just barely start the cup point set screw and the
one (1) ΒΌ - 20 x 1-3/4 inch Pan Head machine screw in
table center holes.
3. Install one 1/4 Iockwasher and Hex Nut on each of the
four (4) screws in the support channels and tighten.
T-NUT
FRONT TABLE
(IN UPSIDE DOWN POSITION)
HOLE FOR TABLE BOTTOM SIDE
HOLD DOWN SCREWS Or TABLE
T-NUT
(TYPICAL)
1/4-20 X 1-3/4" 1/4-20 X I"
PAN HD. SCREW PAN HD. SCREW
FLAT WASHER
FRONT TABLE
_ HEX NUT
LOCKWASHER
4.
5,
Lay the rear table board on edge across the front table
to serve as a straightedge. Sight under this straightedge
to determine whether the front table board is high or
low at its center.
If the front table is high at center, first tighten the
center (1A -- 20 x 1-3/4 inch) hold down screw until the
table is level - then tighten the leveling screw until this
screw is snug.
If table is low at center, first tighten the level4ng screw
until the table is level - then tighten the hold down
scr ew.
If table is not high or low, tighten leveling screw and
center hold down screw snug.
REAR TAiLE BOARD
HOLD DOWN __ 1_-'--._
FRONT TABLE
13
Loading ...
Loading ...
Loading ...