Loading ...
Loading ...
Loading ...
assembly and alignment
ALIGNMENT PROCEDURE
IMPORTANT:
IN ORDER TO OBTAIN MAXIMUM CUTTING
ACCURACY, THE FOLLOWING SIX STEPS
MUST BE CAREFULLY FOLLOWED.
BECOME THOROUGHLY FAMILIAR WITH
THESE STEPS SO THAT YOU CAN ALWAYS
MAINTAIN YOUR SAW IN PROPER
ALIGNMENT. THE ACCURACY OF EACH
ADJUSTMENT IS ALWAYS DEPENDENT
UPON THE ACCURA C Y OF THE PRECEDING
ADJUSTMENT.
After following the 6 step assembly and alignment
procedure and the Basic Saw operation section refer to
Trouble Shooting section if any difficulty is experienced
when performing any sawing operation.
STEP ONE
NOTE: The following adjustment, performed properly, will
result in the work table being parallel to the arm.
ATTACHING AND LEVELING TABLE MOUNTING
SUPPORT CHANNELS.
1. Attach table mounting support channels with four
square head 5/16-18 x 3/4 screws, Iockwashers and flat
washers and nuts. POSITION SCREWS IN CENTER OF
CHANNEL SLOTS, finger tight to permit channels to
"slip" against the base when leveling.
TABLE MOUNTING
SUPPORT CHANNEL
\
SQUAREriD. SCREW
5//16-18 X 3//4
SCREWS
HERE
LOCKWASHER |
FLAT WASHER
BASE
[_._.__J FRONT
MOUNT RAILS USING
THESE HOLES
TABLE MOUNTI NG
SUPPORT CHANNEL
2. Release bevel lock lever, move bevel index lever to the
left and rotate the motor to positidn saw blade end of
shaft down. Lock bevel lock.
3. Unlock and hold arm control lever in index release
position as shown. Position arm against left stop
(approximately 50 ° miter). Loosen carriage lock knob
and position carriage directly over left hand channel.
NOTE: For _afety reasons in accordance with the UL
standard, stops have been provided to prevent 360 °
rotation of the radial arm.
4. Slide the arbor wrench handle between end of motor
shaft and mounting channel to act as a feeler gauge.
Carefully lower the motor with elevation crank until
the end of shaft is just touching the arbor wrench. The
wrench should slide back and forth with only slight
resistance. T_0hten screw "'A".
NOTE: Do not change this elevation setting until both
left and right hand table support channels have been
adjusted.
UNLOCK
LOCK
INDEX RELEASE
ARBOR WRENCH
SCREW "A"
, 12
Loading ...
Loading ...
Loading ...