Loading ...
Loading ...
Loading ...
Installation
Instructions
Range
In the Commonwealth
of Massachusetts
• This product must be installed by a licensed
phunber or gas fitter.
• When using ball Wpe gas shut-off valves, they shall
be the T-handle type.
• A flexible gas connector, when used, must not
exceed 3 fl_et.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54,
latest edition. In Canada, installation must conform
with the current Natural Gas Installation Code,
CAN/CGA-B149.1 or the current Propane Installation
Code, CAN/CGA-B149.2, and with local codes where
applicable. This rmlge has been design-certified by
CSA International according to ANSI Z21.1, latest
edition mid Canadian Gas Association according
to CAN/CGA-I.1 latest edition.
As with any appliance using gas and generating heat,
there are certain safet)" precautions you should follow.
You will find these precautions in the Important Safety
Information section in the front of this manual. Read
them careflfllv.
• IMPORTANT - S ,,ethese
instructions fin" local electrical inspector's use.
• IMPORTANT - Obse ve ,ll
governing codes and ordinances.
• Note to Installer - i,eave these instructions
with the appliance aDer installation is completed.
• Note to Consumer - Kee I) this Owner's
Manual and Installation Instructions fl)r fllture
referellce.
• Note - This appliance must be properly grounded.
• Servicer - The electrical diagram is in an envelope
attached to the back of the range.
• Skill level - Installation of this appliance requires
basic mechanical skills.
• Proper installation is the responsibility of the
installer
• Product tailure due to improper installation is not
covered under the Warranty.
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or
other flammable vapors m_d liquids in the vicinity of
this or any other appliance.
If you smell gas:
Open windows.
O Don't touch electrical switches.
O Extinguish any open flame.
hmnediatelv call vour gas supplier.
TOOLS YOU WILL NEED
Phillipsscrewdriver
_:_====_
Flat-bladescrewdriver Open-endor
adjustablewrench
Penciland ruler
Level
Pipewrenches(2)
(one for backup) Drill, awl ornail
MATERIALS YOU MAY NEED
• (;as line sh ut-off xalxe
• Pipe joint sealant or Ui:api)roved pipe thread tape
with Teflon* that resists action of natural and I,P gases
• gle_ble metal appliance connecU)r (l/2" I.D.)
A B-toot length is recommended fin" ease of installation
but other lengths are acceptable. Never use an old
connector when installing a new range.
• Flare union adapter fin" connection to gas suI)ply line
(3/4" or 1/2" NPT x 1/2" I.D.)
• Flare tliliOil adapter for COililectioil to l)i'essl.n'e
regulator on range (1/2" NPT x 1/2" I.D.)
• liquid leak demctor or soap)' wateL
• I_g bolt or l/2" O.D. sleeve anchor (fin" concrete
floo_ only).
*'[\_flon:Registered trademark of DuPont
42
Loading ...
Loading ...
Loading ...