Loading ...
Loading ...
Loading ...
,0
iiiiiiiiiiiii",,i_'i_5:i:i:i:i:i:i:i:i:ilili_ii_!!i_!!
iiiiiiiiiiiiiiiiiii ii ii ii ii ii i iii ii ii i i i i i i i i i i ii ii i!
,0
,0
-€
q
m
Care and cleaning of the range.
Make sure the slot f17the burner head
is positioned over the electrode. Use a
sewing needle or twist-tie to unclog
the small hole fl?the burner head.
Burner cap isproperly seated.
Burner cap is NOTproperly seated.
Burner Caps and Heads
Burner caps
i,ifl off when cool. _,V_sh burner caps
in hot, soai/)' water and rinse with clean
water: You may scour with a plastic scorning
pad to remove bm'ned-on fi)od particles.
Center Griddle Burner
For proper ignition, make sm'e tile
small hole in the section that fits over the
electrode is kept open. A sewing needle
or wire twist-fie works well to tmclog it.
Theslits intheburnerheadsmustbekeptclean
at aft times for an even, unhampered flame.
Clogged or dirty burner ports or electrodes
will not allow tile burner to operate properly;
Any spill on or arotmd an electrode must
be careflfllv cleaned. Take care to not hit an
electrode with anything hard or it could
be damaged,
You should clean the bm'ner caps and
burner heads routinely, espedally alter bad
spillove_s, which could clog the openings
in the bm'ner heads. Lilt offwhen cool.
To i'eillove btli'ned-on loo(l_ soak tile
bm'ner heads in a solution of mild liquid
detergent and hot water for 20-30 minutes.
For i//oi'e SttlbboFn stains, tlse a toothbrush.
NOTE"Donot usesteelwoolor scouringpowders
tocleantheburners.
After cleaning
Before putting tile bm'ner caps and heads
back, shake out excess water and then (h_'
them thoroughly by setting in a wam_ oven
fi)r 30 minutes.
RoundBurner Bases
Tile rotmd bm'ner bases are not remo_fl_le.
only tile caps may be removed fi)r cleaning.
To clean tile burner bases, use soapy water
and a plastic sco/wing pad. _*\]i)e clean with
a damp cloth.
Make sure that no water gets into tile
bm'ner bases. Nlow them to (h'v fldlv
betore using.
Replacement
Replace tile bm'ner caps. Make sm'e that
the caps are replaced in the correct
location. There is one owd (center) head
and cap assembly: There is one small, one
medimn, one large, and one extra large
round burner cap.
Ova neaaand Ca0
72r Srnao.rner
_ head;nd ca0
© . <3
trent 0f _Jl
/
I
Largeburner Extra[al#e0urnel
qeaa al)_J cap nea0 alia ca[
36
Loading ...
Loading ...
Loading ...