Loading ...
Loading ...
Loading ...
33
www.spirittness.com
WIRELESS HANDLE CODING STEPS
1. After replacing the battery (CR2032), the wireless handle control needs to be coded again.
2. When the console is turned on again, press and hold the Up or Down handle button for 3 seconds to complete
the coding between console and handlebar.
3. Check if coding between console and handlebar is successful: Press Start button on the console and then press
Up or Down button on the handle to see if LEVEL on LCD changes. If yes, it is successful otherwise go back to
step 1 to repeat Coding between Console and Handlebar.
GENERAL MAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two reasons:
a. The hardware was not sufciently tightened during assembly. All bolts that were installed during assembly need to be
tightened as much as possible. It may be necessary to use a larger wrench than the one provided if you cannot tighten
the bolts sufciently. I cannot stress this point enough; 90% of calls to the service department for noise issues can be
traced to loose hardware.
b. If squeaks or other noises persist, check that the unit is properly leveled. There are 2 leveling pads on the bottom of the
rear stabilizer, use a 14mm wrench (or adjustable wrench) to adjust the levelers.
Loading ...
Loading ...
Loading ...