Loading ...
Loading ...
Loading ...
W415-1676 / A / 03.17.17
7
EN
2.3 GENERAL INFORMATION
2.3.1 FEATURES
Shipped with appliance:
Installation manual
Ember Strip
Approximate Heating Capacity up to 1,000 square feet (92 square meters).
CALIFORNIA PROP 65 WARNING:
Use of this product may produce smoke which contains
chemicals known to the State of California to cause
cancer, birth defects, or other reproductive harm.
Do not use makeshift compromises during installation.
Do not block or restrict air, grille or louvre openings! Do
not add a hood.
Burning your appliance with the door open or ajar creates a fire hazard that may result in a house and/or
chimney fire.
All venting connections must be in compliance with the chimney manufacturers installation instructions.
Clearances referred to throughout this manual are the minimum requirements.
Your appliance must be installed in accordance with all national and local building code standards and
the standard of Chimney and Appliances, Vents and Solid Fuel Burning Appliances NFPA #211. Consult
the authority having jurisdiction (such as municipal building department, fire department, fire prevention
bureau, etc.) to determine the need to obtain a permit. If you are in doubt about the proper installation for
your situation, contact your dealer or local building or fire official. The manufacturer does not guarantee
that this appliance and its options will completely heat your entire home.
Expansion / contraction noises during heating up and cooling down cycles are normal and to be expected.
It is recommended that in all cases, the appliance be secured to the floor. Use the pallet packing brackets
to accomplish this.
THE NZ8000 HAS BEEN EPA QUALIFIED.
• Depending on the loading method and size of
log, maximum length of 32" (81.3cm).
• Large glass door for maximum visibility.
• Fully refractory lined firebox.
• Closable outside air damper.
• Closable flue damper.
• Shipping weight 1150lbs (521kg).
• Flue outlet diameter 12" (30.5cm).
• Max fuel load 60lbs (27kg).
• Max fuel height, halfway or top of the first
firebrick.
• Safety tested to: ULC S610 and UL 127.
• Emissions tested to: ASTM E2515 and ASTM
E2558 for U.S. EPA Low Mass Wood-burning
Fireplace voluntary program phase 2 emissions
level (NZ8000 only).
DO NOT LET THE APPLIANCE BECOME HOT ENOUGH FOR ANY PART TO GLOW RED.
2.3.2 THIS CORDWOOD FUEL FIREPLACE
2.3.3 PACKING LIST
The location of windows, doors and the traffic flow in the room where the appliance is to be located should be
considered. If possible, you should choose a location where the chimney will pass through the house without
cutting a floor or roof joist.
Loading ...
Loading ...
Loading ...