Loading ...
Loading ...
Loading ...
Cleaning and care
66
To make it easier to clean the oven:
Remove the door.
Take out the side runners with
FlexiClip runners (if fitted).
Remove the catalytic enamelled back
panel.
Lower the top heat/grill element.
Removing normal soiling
Removing normal soiling
Remove normal soiling immediately
with warm water, washing-up liquid
and a clean sponge or a clean, damp
microfibre cloth.
Remove all cleaning agent residues
thoroughly with clean water.
This is particularly important for any
parts with a PerfectClean finish, as
cleaning agent residues will impair
the non-stick function.
After cleaning, wipe the surfaces dry
using a soft cloth.
Removing stubborn soiling
(excluding the FlexiClip
runners)
Spilt fruit and roasting juices may
cause lasting discolouration or matt
patches on surfaces. This
discolouration will not affect the
properties of the surface finish.
Do not attempt to remove these
stains. Only use the equipment
specified.
Baked-on deposits can be removed
with a glass scraper or with a
stainless-steel spiral pad (e.g.
Spontex Spirinett), hot water and
washing-up liquid.
Exposure to scouring agents,
abrasive brushes or sponges and
oven cleaner can cause catalytic
enamel to lose its self-cleaning
properties.
Remove the catalytic enamelled
panels before using an oven cleaner.
Using oven cleaners
Very stubborn soiling on PerfectClean
surfaces can be cleaned using the
Miele oven cleaner, which must only
be applied to cold surfaces.
If the oven spray gets into gaps and
openings, a strong odour is
generated during subsequent
cooking programmes.
Do not spray the oven cleaner onto
the roof of the oven compartment.
Do not spray the oven cleaner into
the gaps and openings of the oven
compartment walls and rear wall.
Follow the instructions on the
packaging.
Oven cleaners from other
manufacturers must only be used in a
cold oven and for no longer than a
maximum of 10minutes.
You can then also use the scouring
pad on the back of a washing-up
sponge to remove the soiling.
Remove all cleaning agent residues
thoroughly with clean water.
Dry all surfaces with a soft cloth.
Loading ...
Loading ...
Loading ...