Loading ...
Loading ...
Loading ...
FIG.17
FIG.18
9. SETTING THE DRILL
- 17 -
9.4 WORK TABLE ADJUSTMENT -
FIGS. 17 - 18
For versatility, the work table (Z) can be raised or
lowered, tilted ±45° or rotated 360° around the column.
To tilt the table, tighten nut (AA) clockwise until the
locating pin can be removed from the casting. Store in
a safe location. Loosen the 24mm bolt (AB).
Adjust the table’s degree of tilt and re-secure with
locking bolt (AB). Use the scale as a guide.
Alternatively use a protractor off the table to the drill bit
for more accuracy.
When the table is back in a level position insert the
location pin for the factory setting. Move the nut along
the thread until the end of the thread is protected by
the nut, allowing use of a small hammer to tap the pin
in place.
To raise/lower the table working height, loosen locking
handle (AC) and turn the height adjustment crank
handle (AD) to raise or lower the table. Alternatively
while locking handle (AC) is loose the table can be
rotated 180° to further increase the distance between
the chuck and workpiece. When the adjustments are
complete re-secure locking handle (AC).
The slots in the work table and base can
accommodate locking bolts to secure a small vice
enabling safe clamping of the workpiece.
CAUTION: A drill bit snagging on a piece of work will
violently grab the piece of material, whipping it round
and is likely to result in personal injury. Always ensure
the workpiece is securely clamped.
(Z)
(AC)
(AD)
(AB)
(AA)
Loading ...
Loading ...
Loading ...