Loading ...
Loading ...
Loading ...
FIND YOUR PROBLEM POSSIBLE CAUSE HOW TO FIX IT
HERF
OPERATING PROBLEMS IN THE DRYER
Dryer does not start. Dryer may not be plugged in or plug Make sure the plug is tightly pushed
may be loose, into wall outlet.
House fuse blown or circuit breaker
tripped.
Check/reset circuit breaker and/or
replace fuse. Do not increase fuse
capacity. If the problem is a circuit
overload, have corrected by a
qualified electrician.
Power outage. Check house lights. Call local electric company.
Timer knob not in correct position. Turn Timer knob clockwise until the
indicator is advanced a little further
into the cycle, push the Start button
and hold it in for two seconds.
Start button has not been pushed long Push Start button and hold it in for
enough, two seconds.
Dryer door not closed. Push dryer door closed.
Motor overheats due to overloading. Allow motor to cool down for about
30 minutes. Reduce clothes load.
Push Start button to restart. If prob-
lem persists, cal! for service.
Therma! Limiter tripped. Call authorized service person for
replacement.
More than one Fabric Temperature Carefully push only one Fabric
control button has been pushed. Temperature control button.
Dryer runs, but won't heat.
House fuse blown or circuit breaker
tripped (electric models only).
Electrical line is overloaded.
Contact an electrician. Dryer must
be on a separate circuit. Reset circuit
breaker or replace fuse.
Gas supply valve is not open (gas
models).
Check and make sure supply valve is
open. See Installation Instructions
for procedure. If there is still no heat,
call a qualified gas service person or
authorized WCI servicer.
LP Gas supply tank is empty or a Refill or replace tank. Dryer should
utility interruption of natural gas heat when utility service is restored.
occurred (gas models).
Dryer does not have enough air supply Refer to Installation Instructions for
to support the burner flame (gas proper installation.
models).
22
Loading ...
Loading ...
Loading ...