Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
,, ,,,H,,,,,, ,, ,,,
FRONT WHEEL TOE-IN ADJUSTMENT
Front w;_eel toe-in is required f0rpropersteedng opei'ation°
Toe-in was set at the factory and adjustment should not be
necessary If parts tn the front axis or steering mechanism
have been replaced or damaged, cheek toe-in and adjust
if necessary.
TO CHECK TQE-IN (See Fig 28) -
- Posttion front wheels straight ahead
• Measure distance between wheels at front and rear o!
tires (dimensions "A" and "B")
• FrOnt dimension "A" should be 1/8" to 1/4" less than
rear dimension "B"
TO ADJUST TOE-IN (See Figs. 28 and 29) -
• Loosen jam nuts at adjustment sleeves on tie rod.
• Adjust lie rod untit dimension "A" is 1t8" to1/4" less than
dimension "B".
• Tighten jam nuts securely.
FIG, 28
_'_:_, ADJUSTMENT
/ /_,_r_ /"-'1 SLEEVES
t
JAM NUTS _ ,,_1/ "/_;;}
t ((U;
TiE ROD _',!:.:"*
FIG. 29
FRONT WHEEL CAMBER
The frontwheef camber Is net adjdstabte on your tr:actor: If
damage has occurred to aflect Ihe front wheel combe;t,
contact you_" nearest authorized service centeddepart:
ment r
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig 30)
• Block up axle securely.
• Remove axle cover, retaining rlngend washers to allow
wheel removal
• Repair tlre and reassembie_
• Replace washers and snap retaining ring securely in
axle groove
• Reptace axle cover
25
WAS
FIG. 30
REAR WHEEL -
• Block rear axle securely
• Remove five (5) hub belts Io allow wheel removal.
• Repair tire and reassemble. Replace and tighten hub
bolts securely
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 31)
CAUTioN: Lead-acid bat{eries gener-
ate explosive gases. Keep sparks, flame
and smoking materials away from bat-
terles. A|ways wear eye protection
when around batteries.
H,, '1 =
if your battery is too weak to start the engine, it should be
recharged. If "jumper cables" are used for emergency
starting, follow this procedL=re:
IMPORTANT: YOUR TRACTOR tS EQUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES
'TO ATTACH JUMPER CABLES -
• Connect each end of the RED cable Io the POSITIVE
(+) termfnal of each battery, taking care not to short
against chassis _
• Connect one end of the BLACK cable Io the NEGA-
TIVE (-) terminal of fully charged battery
• Connect the elher end of the BLACK cable to good
CHASSIS GROUND, away from fuel tank and battery,
TO REMOVE CABLES, REVERSE ORDER -
• BLACK cable first {rein chassis and then from the fully
charged battery
RED cable last from both batteries,
"POSITIVE" 1+) "NEGATIVE" {-)
L H. PANEL
4/
I
FIGo 31
Loading ...
Loading ...
Loading ...