Loading ...
Loading ...
Loading ...
26
Changing The Water and Air Filters
Your refrigerator is equipped with separate
water and air filtering systems. The
water filter system filters all dispensed
drinking water, as well as the water used
to produce ice. The air filter removes
odors and impurities from the refrigerator
compartment.
Replacement
Water Filter
Remove Two
Protective Caps
Push Water Filter Button
Water Filter
Button
Water Filter
Cartridge
NOTE
The control panel includes controls to
monitor the status of your water and air
filters. See the Controls section for more
information.
About your advanced water filter
Water filter
The water filter is located at the lower left
side of the fresh food compartment.
Replacing your PureAdvantage
TM
water filter
In general, you should change the water
filter every six months to ensure the
highest possible water quality. The Water
Filter Status light on the Touch Panel
prompts you to replace the filter after a
standard amount of water (400 gallons)
has flowed through the system.
If your refrigerator has not been used for a
period of time (during moving for example),
change the filter before reinstalling the
refrigerator.
It is not necessary to turn the water supply
off to change the filter. Be ready to wipe
up any small amounts of water released
during the filter replacement.
1 Turn Off the ice maker on the control
panel.
2 Push the filter release button above
the cartridge to disconnect it.
The PureAdvantage
TM
ice
and water filter system
is tested and certified by
NSF International to NSF/
ANSI Standards 42 and
53 for the reduction of
claims specified on the
performance data sheet.
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system. Systems
certified for cyst reduction may be used
on disinfected waters that may contain
filterable cysts.
• Rated Capacity - 400 gallons for
PureAdvantage
TM
ice and water filter
• Rated service flow - .5 gallons per
minute
• Maximum Rated Pressure - 100
pounds per square inch
• Recommended Minimum Operating
Pressure: 30pounds per square inch
• Operating Temp.: Min. 33°F, Max.
100°F
3 Slide the old water filter cartridge
straight out of the housing and
discard it.
4 Unpack the new filter cartridge and
remove the two protective caps
covering the inlet and exit of the filter.
Slide the filter gently into the housing
until it stops against the snap-in
connector at the back of the housing.
Loading ...
Loading ...
Loading ...