Loading ...
Loading ...
Loading ...
17
Automatic Ice & Water Maker/Dispenser
Priming the water sup-
ply system
1 Begin filling the tank by pressing and
holding a drinking glass against the
water dispenser paddle.
2 Keep the glass in this position until
water comes out of the dispenser. It
may take about 1½ minutes.
3 Continue dispensing water for about three
minutes to flush the system and plumbing
connections of any impurities (stopping to
empty the glass as necessary).
Ice maker operation & care
After the refrigerator is installed properly
and has cooled for several hours, the ice
maker can produce ice within 24 hours.
The ice maker will fill the ice bin from the
rear. You must dispense some ice to force
the ice forward in the bin. This will allow
the bin to fill completely.
IMPORTANT
Your ice maker is turned on at the factory
so it can work as soon as you install
your refrigerator. If you cannot connect a
water supply, set the ice maker’s On/Off
icon to Off and turn off the water supply
valve; otherwise, the ice maker’s fill valve
may make a loud chattering noise when
it attempts to operate without water.
CAUTION
For proper dispenser operation,
recommended water supply pressure
should fall between 30 psi and 100
psi. Excessive pressure may cause
water filter to malfunction.
NOTE
The water dispenser has a built-in device that
shuts off the water flow after three minutes of
continuous use. To reset this shutoff device,
simply release the dispenser paddle.
NOTE
The ice maker also has a built-in plastic
signal bale arm that automatically stops
ice production when the ice bin is full.
This signal arm should not be used to
manually stop the ice maker.
IMPORTANT
Turning off the ice maker will result in
existing ice melting in the bin.
IMPORTANT
Turning off the ice maker will disable the
ice dispenser. You will still be able to
dispense water.
Turning the ice maker on and off
Ice production is controlled by the ice
maker’s On/Off icon on the control panel.
Press and hold the “Ice Off” icon for three
seconds to turn the ice maker “ON” or
“OFF”. When the ice maker is “OFF” the
red LED above the icon will be illuminated.
NOTE
Dispensed water is not chilled. For
colder water, add ice to cup or container
before dispensing water.
Using the ice maker after installation
Before making ice for the first time, be
sure to prime the water supply system.
Air in new plumbing lines can result in
two or three empty ice maker cycles.
Furthermore, if the system is not flushed,
the first ice cubes may be discolored or
have an odd flavor.
Loading ...
Loading ...
Loading ...