Loading ...
Loading ...
Loading ...
24
Insignia Single- and Dual-Tap Kegerator/Beverage Cooler
www.insigniaproducts.com
Troubleshooting - cooler
You can solve many common beer dispenser problems easily, saving
yourself the cost of a possible service call. Try the suggestions below to
see if you can solve the problem before calling the service center.
Abnormal beer taste
and/or smell.
System requires cleaning. See “Maintaining your kegerator/beverage cooler.”
System contamination. Check hoses for possible air leaks.
The beer has exceeded its shelf
life.
Replace the beer keg with a fresh one.
Caution
Do not try to repair your kegerator/beverage cooler yourself.
Doing so invalidates the warranty.
Problem Possible cause Possible solution
The kegerator/beverage
cooler does not operate
The kegerator/beverage cooler
is unplugged.
Make sure that the kegerator/beverage cooler is plugged in and
that the plug is pushed completely into the outlet.
The fuse on the circuit is blown
or the circuit breaker is
tripped.
Check the house fuse/circuit breaker box and replace the fuse or
reset the circuit breaker.
Power failure. If a power failure occurs, the kegerator/beverage cooler turns
off. Wait until the power is restored, then turn it on again.
The cooler door does
not close completely
The door was not properly
installed.
Make sure that the door was properly installed.
The shelf is out of position. Adjust the shelf properly.
The door gaskets are dirty. Clean the door gaskets.
The cooler is not level. Level the cooler with the leveling feet.
The cooler is not cold
enough
The door has been opened too
often or was not closed
properly.
Make sure that the door is closed properly.
You have just added a large
amount of warm beverage to
the cooler.
Allow time for the new beverage to cool, then check again.
The temperature control is set
too warm.
Set the control to a colder setting.
Problem Possible cause Possible solution
Loading ...
Loading ...
Loading ...