Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENT
HOW TO REPLACE THE FUSE
Ifthe fuse is blown, the engine will not start The location of the fuse
is next to the battery Remove the fuse and replace with a 15 amp
automotive fuse (Figure 39)
15amp
_ AutomoUveFuse
Figure39
HOW TO SET THE CUTTING HEIGHT
The cutting height is set at thefactory from tl/2 to 4 inches. To lower
or raise the cutting height, make an adjustment to the lifter rod as
follows.
1_ Move the lift lever to the lowest position
2. Disconnect the lifter rod from the lifter arm (Figure 40).
3. Turn the lifter rod clockwise to lower or counterclockwise to
raise the cutting height
4. Attach the lifter rod to the lifter arm.
5. Move the lift leverto the highest position. Make sure the pulleys
or belt do not touch the bottom of the frame
Hair Pin ""----
\
Wash
Ufter Rod
Figure 40
HOW TO CLEAN THE MOWER HOUSING
,_ WARNING: Before you clean the mower housing,
stop the engine and disconnect the wire to the spark
plug.
Grass and other debris on top of the mower housing can keep the
belt from working correctly For safety and correct operation,
frequently clean the top of the mower housing Remove grass and
debris from around the pulleys and other moving parts
1. Move the lever for the attachment clutch to the ENGAGE posi-
tion.
F-99636 31
2. Clean the top of the mower housing.
3. Move the lever for the attachment clutch to the DISENGAGE
position.
4. Again clean the top of the mower housing
5. After you cutthe grass, clean the bottom ofthe mower housing.
FRONT WHEEL ALIGNMENT
The alignment ofthe front wheels cannot be adjusted Ifthe steering
is damaged and the alignment has changed, see your nearest
authorized service center
Loading ...
Loading ...
Loading ...