Loading ...
Loading ...
Loading ...
HOW TO INSTALL THE SEAT
ASSEMBLY
i :
Use the fasteners shown belowto install theseat. The fasteners are
shown at full size: :_ .... :
:i{B)
'_lx45 :::: ;: i::18x16
..... (D)
2x53 .... 15x88
1 Set the seat bracket on the seat support (Figure 5) Pull the
wire harness between the seat hinge and the seat bracket.
2 Fastenthe seat bracket to the seat support withthe fasten-
.... ers. Do nottightenthe fasteners .....
Seat Hinge
Seat Bracket
i i i ,i
D
Figure 5
3. Carefully remove the protective sleeve and the plastic bagfrom
the seat, Do not damage the wire attached to the bottom of the
seat.
Atign the holes in the seat hinge to the holes in the seat
(Figure 6). Fasten the seat to the seat hinge withthe fasteners
as shown. Tighten the fasteners.
Check the operatingposition ofthe seat. :If:the seat needs to
be adjusted, slide the seat bracket forward orbackward along
the seat adjusting holes as shown Tokeep the seat straight,
tightenthe rear nut and thentighten the two front nuts
Fastenthe connector tothe wire harness. Make sure the tab
on the connector locks intothe wire harness.
WARNING: For correct and safe operation ofthe unit,
fasten the connector to the wire harness. If the
connector is not attached, the engine will stop when
the attachment clutch is engaged.
Seat
Adjustin_°_les "_ gure 6
CHECK THE LEVEL OF THE MOWER HOUSING
NOTE: After the unit is fully assembled, read the Operation
section.
The level ofcut wasset at thefactory To check the levelofcut, mow
a short distance and look at the area that was cut If the mower
housing does not cut level, see the instructionson "How To Level
The Mower Housing" inthe Service And Adjustment section of this
instruction book.
F-99636 t 0
Loading ...
Loading ...
Loading ...