Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENT
HOW TO REPLACE THE MOTION DRIVE BELT
REMOVAL
1. Remove the mower housing See the instructions on "How To
Remove The Mower Housing"
2. Completely push the clutch/brake pedal forward and engage
the parking brake.
3. Try to pull the motion drive belt off the drive pulley If the belt
guides are too close to the drive pulley, loosen the belt
guides (Figure 36)
4. Remove the motion drive belt from the idler pulley
5. Pull the motion drive belt toward the front of the unit.
6. Remove the motion drive belt from the stack pulley. If
necessary, loosen the belt guide atthe stack pulley. A correct
replacement part or assistance is available from an authorized
service center in your area
INSTALLATION
1 Slide the motion drive belt between the stack pulley and the
belt guide, install the motiondrive belt onthe top pulleyofthe
stack pulley. Make sure the "V" side of the belt isagainst the
pulley (Figure 35).
2 Slide the motion drive belt between the belt retainer and idler
pulley Make sure the ftat side ofthe motion drive belt isagainst
the idler pulley. Also, make sure the belt is not twisted
3 Install the motion drive belt around the drive pulley
4. Make sure the motion drive belt is inside all the belt guides
5. Make sure all the belt guides aretight
6 Before you usethe unit, check the adjustment of theclutch See
the instructions "How To Check And Adjust The Clutch".
7 install the mower housing See the instructions"How To install
The Mower Housing"
j Pulley
F_gure35
Stack Pulley
Loosen
BeltGuide
BeltRetainel
Belt Guide
Drive PuIley
O
Figure 36
F-99636 29
Loading ...
Loading ...
Loading ...