Loading ...
Loading ...
Loading ...
LiGHTiNG GAS BURNERS FITTED WiTH FLAME FAILURE
SAFETY DEVICE (Dual Burner)
tn order to light the burner, you must:
Hi
1 - Push and turn the knob in an anti-clockwise direction up to the _ position (maxi-
mum rate of inner crown); push in and hold the knob until the flame has been lit.
The sparks produced by the lighter situated inside the relative burner wilt light the
flame.
tn the event that the local gas supply conditions makes it difficult to light the burner
HI
in _ position, try again with the knob in s_Mposition.
tf there is no mains electrical supply connection, bring a lighted match close to the
burner.
2 - Wait for about ten seconds after the gas burner has been lit before letting go the
knob (safety device activation delay).
3 - Adjust the gas valve to the desired position.
tf the burner flame should go out for some reason, the safety valve will automatically
stop the gas flow.
To re-light the burner, return the knob to the closed position OFF, wait for at least 1
minute and then repeat the lighting procedure.
11
Loading ...
Loading ...
Loading ...