Loading ...
Loading ...
Loading ...
STEP 8
Adjusting the Oven Burner/Broiler Burner
Air Adjustment Shutter, If Necessary
To determine if the oven/broiler burner flames are burning
properly, first remove the oven bottom,,
To remove the oven bottom:
1. Remove the knuried
screws holding down
the rear of the oven
bottom.
2. Grasp the oven
bottom at the finger
slots on each side..
3. Lift the rear of the
>nHl
Ovenbottom
oven bottom enough to clear the lip of the range
frame, push it back, and then pull it up and out
With the oven bottom
removed, properly c
adjusted flames should c
have approximately 1"
(25 cm) blue cones
and, if range is supplied
with natural gas, should
burn with no yellow
tipping. (With most LP "_'_
gas, small yellow tips at the end of outer cones are
normal) Flames should not lift off the burner ports°
if lifting is observed, gradually reduce air shutter
opening until flames are stabilized..
The shutter for the oven burner is near the back
wall of the oven and behind the broiler compartment°
Open the broiler compartment. See the Care and
Cleaning section in this guide°
Remove the metal .___ 't
models! at the I I 'PiLAi,adjustmentshutterI /
rear or me cavity. L...._ t "
The air adjustment __ / C _ "
shutter is behind I_ _._._ -
this shield. To adjust _-'_'_"_ /
the flow of air to _ JI_""_'_%. "4L._ ._,
the burner, loosen _ _ - -_ "_._-_
the Phillips-head _ °_"k_.'_",,,,"_\
screw and rotate /__Y"'!. "%.. _'_
the shutter to allow ._/_<.J--f I \ "_
more or less air J"_'_\ ..... ,__.=_,., "*,q,.
into the burner tube. _\ _w_,=,_,,,_,u -,
STEP 9
Leveling the Range
Raise
1. Instali the oven shelves range
in the oven, then position
the range where it will be Lower
installed° See the Oven range
Shelves section.
2. Check for levelness by
placing a spirit level or a
partially filled cup of water
on one of the oven shelves.
If using a spirit level, take
two readings--with the level
placed diagonally first in
one direction and then the
other.
3.Open the broiler compartment. The front leveling legs
can be adjusted from the bottom and the rear bgs can
be adjusted from the top or
the bottom..
4. Use an open-end or
adjustable wrench to
adjust the leveling legs
until the range is level
5. After the range is level,
slide the range away
from the wall so that the
Anti-Tip device can be installed..
Io__ Lower
i. _ range
Lege'er'_"E_"
35
Loading ...
Loading ...
Loading ...