Loading ...
Loading ...
Loading ...
I [SETUP] _ [QUICK START] _ [ON]
2 Close the LCD monitor while the
mode switch is set to _.
This unit will resume recording/pause mode about 0.6 seconds after the LCD monitor is reopened.
• When in quick start standby mode about 60% of the power used in recording pause mode is
being consumed, so the recording time will be reduced.
1 Select the menu. (-) 27) • In the quick start mode, the zoom
magnification becomes 1× and the picture size
I differ from what it was before quick start
may
standby mode.
• If [POWER SAVE] (4 28) is set to
[5 MINUTES] and the unit automatically goes
into quick start standby mode, close the LCD
monitor and then open it again.
• If the unit is exposed to vibration or shock, the
time for the quick start mode to start may be
slightly longer than 0.6 seconds.
The status indicator O flashes green and the unit
goes into quick start standby mode.
• The lens cover does not close.
3 Open the LCD monitor.
The status indicator O lights red and the unit is
put into recording pause approx. 0.6 seconds
after it is turned on.
• Set [QUICK START] to [OFF] to cancel the
quick start mode.
• Quick start standby mode is canceled if
about 5 minutes has elapsed
mode switch is set to []
unit is turned off
• In the 24p digital cinema setting, the required
time for the quick start operation is slightly
longer than 0.6 seconds.
• In the quick start mode, it may take some time
for automatic white balance to adjust, if the
scene being recorded has a light source
different from the scene last recorded. (When
the MagicPix function is used, however, the
white balance of the scene Iast recorded is
retained.)
39
VQT1N45
Loading ...
Loading ...
Loading ...