Loading ...
Loading ...
Loading ...
Quick Guide
• Charging the battery
Charging lamp
[CHARGE] O
Lights up:
Charging
Goes off;
completed
1 Connect the AC cable to the AC adaptor
and the AC outlet.
2 Insert the battery into the battery charger
by aligning the arrows.
• Inserting the battery
Open the LCD monitor and install
the battery by inserting it in the
direction shown in the figure.
• Operate the mode switch while at the same
time pressing in the lock release button if
changing from OFF to another mode.
• Status indicator 0
• To turn off the power, set the mode switch to
OFF.
• Inserting/removing an SD card
O Insert the battery until it clicks and locks.
• How to turn on the power
Turn on the power by sliding the
mode switch to _ or [] while
pressing the lock release button O.
• When this unit is processing data, the
access lamp O lights up.
1 Set the mode switch to OFF.
2 Open the SD card cover while sliding the
SD CARD OPEN lever 0.
3 Insert/remove the SD card.
• When inserting an SD card, face the terminaI
side O in the direction shown in the illustration
and press it straight in as far as it wiii go.
• When removing the SD card, press the center
of the SD card and then pull it straight out.
4 Securely close the SD card cover.
• Securely close it until it clicks.
• Language selection
1) Press the MENU button, then select
[LANGUAGE] and press the cursor button.
2) Select [English] and press the cursor button.
12
VQT1N45
Loading ...
Loading ...
Loading ...