Loading ...
Loading ...
Loading ...
ASSEMBLING TABLE EXTENSIONS
See Figure 10.
• Locate the table extensions and the small hard-
ware bag with the following:
8 hex bolts (5/16-18 x 1-1/4 in.
8 hex nuts (5/16-18)
16 flat washers (5/16 in.)
_1, WARNING: The table extensions not only
provide a better cut on the workpiece but help
protect you. Serious injury can result from
workpiece binding or kickback due to twisted
rails or a misaligned ripfence.
• With the saw upside down, align the extensions
with the table with the bevel edges in front. Put a
flat washer on each bolt. Attach the extensions to
the table by inserting the bolts from the direction of
the table.
• Slip the remaining flat washers and hex nuts on the
bolts. Lightly tighten them with a 12 mm wrench.
• Get help to stand the saw assembly upright using
the center saw table. Do not grasp the saw by the
extensions.
_1, WARNING: The extensions are very heavy. Do
not lift the saw table without help. Keep your
knees bent and liftwith your legs, not your back.
Ignoring these precautions can result in back
injury.
ALIGNING TABLE EXTENSIONS
See Figure 11.
A good alignment allows the railsto slide on easily.
• Stand at the front of the saw and line up the front
edges of the table and extensions.
• To align extensions without damaging the table
saw, put a block of wood at the front of the table
where the extension meets the table, and tap the
block with a hammer. Check and repeat until the
front edges are even.
• Lift each extension slightlyuntil it is higher than the
table (if necessary, place a blockof wood below
and tap upward). Center the block over the edges
and tap it. Recheck the front alignment. If it is
even, tighten the screws with a 12 mm wrench.
BLOCKOFWOOD
SAWTABLE
EXTENSION
TABLE
EXTENSION
SAW
,BASE
VIEWED FROM SIDE
SAWTABLEEDGE
TABLEEXTENSIONEDGE
FORWARD
HEX
NUT
HEXBOLT
FLATWASHER
Fig. 10
VIEWED FROM FRONT
TAPHERE
SAWTABLEEDGE !
_lm TAP
HERE
TABLEEXTENSION
Fig. 11
21 CRRFTSMRN*TABLESAW315.228510
Loading ...
Loading ...
Loading ...