Loading ...
Loading ...
Loading ...
Setting Double Ring Burner (some models)
The versatile Double Ring surface burner offers a complete
range of gas surface settings from the same burner
position.
At the lowest setting, only the burner's inner ring is active,
using a smaller flame perfect for simmering. The burner's
outer ring when set for HI will provide a gas flame that may
be used to bring a large pan of liquid to boil quickly.
__b'i_'¸_¸i_¸_¸¸¸¸¸¸_!¸¸¸¸¸¸iii!
:_!_i!¸!¸_¸¸¸¸_¸_.... _ _ _
Figure 11: Burner at highest (L) setting and simmer (R)
Operating the Double Ring Burner:
,
,
Push right front surface burner control knob in and turn
counterclockwise out of the OFF position and rotate to
the LITE position.
Visually check that both inner and outer rings for the
Double Ring burner are lit (Figure 11). Once lit, turn the
control counterclockwise and adjust to the desired
flame size.
3.
When adjusting for a low or simmer type flame setting,
continue to rotate the control knob counterclockwise
from HI setting towards LO (Figure 12). When the knob
is turned close enough towards the LO setting, the
flame for the outer ring portion of the burner will turn off
leaving only the inner burner with a flame for simmering
(Figure 11). Make any further flame adjustments as
needed..
Figure 12: Setting the double ring burner
Dual burner head (some models)
Burner cap
cap lip
Burner
"_"-_ Burner head
Burner
ea
Burner caps
Figure 13: Placing burner caps correctly
Do not place flammable items such as plastic salt and
pepper shakers, spoon holders or plastic wrappings on the
cooktop when it is in use. These items could melt or ignite.
Potholders, towels or wooden spoons could catch fire if
placed too close to the range cooktop.
Do not place aluminum foil, or any material that can melt on
the range cooktop. If these items melt they may perma-
nently damage the cooktop surface.
Do not cook with the surface control knob left in the
LITE position. The electronic ignitor will continue to
spark if the control knob setting remains in the LITE
position.
When setting any surface control knob to the LITE
position, all electronic surface ignitors will spark at the
same time. However, only the surface burner you are
setting will ignite.
Never place or straddle a cooking utensil over two
different surface cooking areas at the same time. This
can cause uneven heating results.
In the event of an electrical power outage, the surface
burners can be lit manually. Use caution when lighting
surface burners manually. To light a surface burner,
hold a lit match to the burner head, then slowly turn
the surface control knob to LITE. After burner lights
push in and turn knob to desired setting.
Loading ...
Loading ...
Loading ...