Loading ...
Loading ...
Loading ...
Installation instructions 1-71 l_
Levelling the dryer
Check the dryer is level, and make necessary adjustments to the front leveling feet.
Therearlevellingfeetareselfadiusting.
Final installation check list
Check that:
, No plastic or flexible metal foil is used in the exhaust ducting.
, Exhaust is rigid ducting or thick wall flexible metal ducting.
, All joints in the ducting are made with duct tape. It must not be connected with screws or other
= Ducting is clean and is connected to the dryer. ....
, Inserts are fitted to the two front feet. }
, Dryer_s_eve_acrossthefront.
Additionaly for electric dryer models only, check:
o If installation is 208V, specialelement kit has been fitted (seepage 21 ).
° Dryer is plugged or directly wired into an approved fitting and is properly grounded.
° Dryerstarts,heats,coolsandshutsoff.
° Customerhasbeenshownhowtousethedryer.
Additionally for gas dryer models only, check:
o Dryer isplugged intoan approved fittingand isproperlygrounded.
o All fittings in the gas line are tested for leaks.
o Exhaust temperature increases, to confirm ignition has occurred.
- If ignition does not occur initially, it may be due to air in the gas lne or low voltage power supply.
- Thegasregulatorvalvemayfa_ltoopen_fthepowersupplyfallsbelow_0_Volts.
- If the gas fails to flow or does not ignite, the dryer will automatically switch off.
° Customerhasbeenshownhowtousethedryer.
note:s, dryershaveadrumreversalfeaturetoreduceclothestangle.Throughoutthedrying
cycle the motor will run for four minutes, then stop and run in the opposite direction for forty
seconds before reversing again.
Loading ...
Loading ...
Loading ...