Loading ...
Loading ...
Loading ...
Installation instructions
Gas requirements (gas models only)
The installation must conform with LocalCodes, or in the absence of LocalCodes,to the
National Fuel GasCode ANSI Z223.1/NFPA54 or the Canadian Natural Gasand Propane
installation Code, CSAB149.1.
E×D[osion Hazard
hstalations must be performed by a qualified or licensed contractor_
plumbe_) or gasfitter qualified or licensed by the state, province, or region
where this appliance is being instaled.
Use a new AGA or CSA approved gas supply line°
hstal a shut-off vaive in an accessible place°
Only use a gas shut-off valve approved for use within the state, province, or
region where this appliance is being instaled°
Securely tighten al gas connections.
If connecting to LP Gas, have a qualified person make sure gas pressure
does not exceed 13" (330 ram} water column.
Fa/ure to folow these instructions can result in death, explosion, or fire.
Gas type
Your dryer must have the correct burner for the type of gas in your home. Burner information
is located on the rating plate located on the rear of the console. If this information does not
agree with the type of gas available in your home, contact your local Fisher & Payke[ supplier or
service center.
Natural gas
This dryer is supplied ready for use with Natural Gas.
it is design certified by UL international for LP (Propane or Butane) Gaseswith the appropriate
conversion.
LP gas conversion
if the dryer is to be operated on LP (Liquid Propane or Butane) Gas, the dryer must be
converted. To do so, use only the approved Fisher & Payke[ conversion kit [isted in Accessories
on page 7. Do not use with a different gas without consuJtJng the serving gas suppJier.
The dryer must be converted for safe and proper performance by qualified service or installation
personeL
Conversion kits for Natura[ and LP Gas are avaiJabJe from your [oca[ Fisher & Payke[ DeaJer
(see Accessories page 7). If other conversions are required, check with your [oca[ gas utJJity for
specific information concerning conversion requirements.
Loading ...
Loading ...
Loading ...