Loading ...
Loading ...
Loading ...
E L I T E
CAREANDCLEANING
RemovableParts (cont.)
Broil Stop Position
'/'/_//
Hinge
!i!
TO REMOVE
1. Open the door to the broil stop
position,
2. Grasp the door at each side and
lift up and off the hinges. DO NOT
LIFT DOOR BY THE HANDLE.
_p ,111iiii, /1_,111,1 I"1 ' ._
_ AUTION: When the
door is removed and
the hinge arms are at
the broil stop position,
as a precaution, cover the
hinge arms with toweling or an
empty paper towel roll. Do not
bump or try to move the hinge
arms while working in the oven
area. They could snap back,
causing injury to the hands or
damage the porcelain finish of
the front frame.
TO REPLACE
1, Make sure the hinge arms are in the
broil stop position,
2, Lift the door by the sides,
3. Line up the slots at the bottom edge
of the door with the hinge arm&
4. Slide the door down onto the hinge
arms as far as it will go
5. Close the door,
TO CLEAN OUTSIDE OF DOOR
• Use soap and water to thoroughly
clean the top, sides, and front of
the oven door, Rinse well. You may
also use a glass cleaner to clean
the glass on the outside of the door
Do not let water drip into the vent
openings,
• Spillage of marinades, fruit juices,
tomato sauces, and basting
materials containing acids may
cause discoloration and should be
wiped up immediately, When
surface is coot, clean and rinse.
• Do not use oven cleaners, cleaning
powders, or harsh abrasives on the
outside of the door,
If any stain on the door vent trim is
persistent, use a soft abrasive
cleaner and a sponge scrubber for
best results.
TO CLEAN INSIDE OF DOOR
• Because the area inside the gasket
is cleaned during the self-clean
cycle, you do not need to clean this
by hand.
. The area outside the gasket and the
door liner can be cleaned with a
soap-filled steel-wool or plastic pad,
hot water, and detergent. Rinse well
with a vinegar and water solution.
3O
Loading ...
Loading ...
Loading ...