Loading ...
Loading ...
Loading ...
17
12.6 Function test of the chain brake with the
engine switched off (08 - Page 7)
1. Pull the rechargeable battery out of the
appliance, see chapter 12.3 „Pulling out the
rechargeable battery (03)“
2. To release the chain brake, pull (08/A) the
hand guard (08/1) in the direction of the
handle (08/2). The saw chain can be pulled
through by hand.
3. Push the hand guard (08/1) forwards (08/B)
to switch on the chain brake. It must not be
possible to pull the saw chain through.
12.7 Function test of the chain brake with the
motor switched on (08)
NOTE
Release the chain brake each time
before switching on the chain saw.
1. Hold the chain saw securely and firmly by the
handle and hand grip.
2. Release the chain brake.
3. Switch on the engine.
4. Push the hand guard (08/1) forwards (08/B).
The saw chain and engine must stop
immediately.
12.8 Filling saw chain oil (09 - Page 7)
IMPORTANT!
Danger of damaging the chain saw
The chain saw will be severely damaged
if there is too little or even no saw chain
oil in the tank or it has dried/is sticky.
Dried/sticky saw chain oil can lead to
damage to oil-channelling components
or the oil pump.
Damage also occurs if used oil is used.
The use of used oil leads to
environmental damage!
■
For start-up work, fill saw chain oil
into the tank.
■
Do not use any used oil!
■
Each time before changing the
rechargeable battery at the latest, fill
the tank with saw chain oil again.
The saw chain and the chain bar are continuously
supplied with oil during operation by means of an
automatic oiler system. The saw chain oil
protects against corrosion and premature wear.
There must always be sufficient saw chain oil in
the tank to lubricate the saw chain sufficiently.
To lubricate the saw chain and the chain bar,
only use environmentally friendly, biodegradable,
high-quality saw chain oil. This oil must be
transported and stored in approved and
appropriately labelled containers.
Each time before starting work or changing the
rechargeable battery, check the oil level and
replenish the saw chain oil if necessary:
1. Check the oil level in the viewing aperture of
the tank (09/1). It must always be possible to
see oil. The minimum and the maximum oil
level must not be exceeded.
2. Refill saw chain oil via the filler neck (09/2) if
necessary.
13 OPERATION
DANGER!
Danger of fatal injury and danger of
extremely severe injury.
Lack of knowledge of the safety
instructions and operating instructions
can lead to extremely serious and even
fatal injury.
■
Read and follow all safety
instructions and instructions for use
in these operating instructions as
well the operating instructions which
are referred to before you start using
the chain saw.
■ Comply with working time regulations in force
in your country.
■ Grip the rear saw grip firmly with your right
hand (right-handed operator) and the front
grip with your left hand, and hold them tightly.
■ Do not release the grips for as long as the
engine is running.
■ Do not use the chain saw if you are:
■
Tired
■
Unwell
■
Under the influence of alcohol, medicines
and drugs
13.1 Determining the charge status of the
rechargeable battery (04 - Page 6)
There is a control panel with a push-button (04/1)
and LED charge status displays (04/2 to 04/5) on
the front of the rechargeable battery.
Loading ...
Loading ...
Loading ...