Loading ...
Loading ...
Loading ...
TILTING TABLE
To use the table in a bevel (hired) pos_l_on, loosen the
set screw under table bevel lock wath Hex "L" wrench.
Loosen bevel lock with adiustable wrench.
Tilt table to desired angle by reading bevel scale. Re-
tighten bevel lock and set screw.
BEVEL LOCK
BEVEL SCALE
WARNING: TO AVOID INJURY FROM SPINNING
WORK OR TOOL BREAKAGE, ALWAYS CLAMP
WORKPIECE AND BACKUP MATERIAL SECURELY
TO TABLE BEFORE OPERATING DRILL PRESS
WITH THE TABLE TILTED.
To return table to original position: loosen set screw
and bevel lock, tilt table back to 0° on bevel scale, and
retighten set screw--then tighten bevel lock.
HOLE LOCATION
Make a OENT in the workpiece where you want the
hole..• using aCENTER PUNCH or aSHARP NAIL.
Before turning the switch ON, bring the drill down to
the workpiece lining it up with the hole location.
FEEDING
Pull down on the feed handles with only enough effort
to allow the drill to cut,
Feeding TOO SLOWLY might cause the drill to bum
•.. Feeding TOO RAPIDLY might stopthe motor...
cause the belt or drillto SLIP... tear the workpiece
LOOSE or BREAK the drill bit.
When drilling metal, it may be necessary to lubricate
the tip of the drill with motor oil to prevent burning the
drill tip.
adjustments
WARNING: FOR YOUR OWN SAFETY TURN
SWITCH "OFF" AND REMOVE PLUG FROM POWER
SOURCE OUTLET BEFORE MAKING ANY ADJUST-
MENTS. TO AVOIO INJURY FROM THROWN PARTS
DUE TO SPRING RELEASE, FOLLOW INSTRUC-
TIONS CAREFULLY, AND WEAR EYE GOGGLES.
NOTCH
JAM NUT
(OUTER)
BOSS
CAP
QUILL RETURN SPRING
1. With the chuck at its highest possible position, turn
the depthscale clockwise until it stops and tighten
the depth scale lock. This will prevent the quill drop-
ping while tensioning the spring.
2. Lower table for additional clearance•
3. Work from left side of Drill Press.
4. Place screwdriver in lower front notch of spring
cap, and hold it in place while loosening and remov-
ing jam [outer] nut only.
5. With screwdriver remaining in notch, loosen large
standard [inner] nut (approximately 1(8") until notch
disengages from boss on head. DO NOT REMOVE
THIS NUT.
6. Carefully turn screwdriver counter clockwise and
engage next notch in boss. DO NOT REMOVE
SCREWDRIVER.
7. Tighten standard nut with wrench only enough to
engage boss. Do not overtighten as this will restrict
quill movement.
NUT
(INNER)
.
Move stop nuts and depth pointer to upper most
position and check tension while turning feed han-
dles.
9. If there is not enough tension on spring, repeat
steps 4-8 moving onlyONE notcheachlime and
checkingtensionafter EACH repetition.
10. Propertensionisachievedwhenquillreturnsgently
to full up positionwhen released from 3/4"depth.
11. When there is enoughtension after checking,re-
placejam nut andtightento standardnut.BUT do
not overtightenagainststandard nut.
12. Check quill,whilefeedingto have smoothand un-
restricted movement• If movement is too tight,
loosen jam nut and SLIGHTLY loosen standard
nut until unrestricted.Retightenjam nut.
Loading ...
Loading ...
Loading ...