Loading ...
Loading ...
Loading ...
INSTALLING LIGHT BULB
1. Install a light bulb (not larger than 60 watt) into the
socket inside the head.
ADJUSTING THE TABLE SQUARE
TO HEAD
NOTE: The combination square must be "true." See
"Unpacking and Checking Contents" section for
method.
1. Insert a precision ground steel rod approximately
3" long into chuck and tighten.
2. With table raised to working height and locked on
column, place combination square flat on table be-
side rod.
3. If an adjustment is necessary, loosen the set screw
under bevel lock with 3ram Hex "L" wrench, then
loosen the table bevel lock with a 15116" wrench.
(These adjustments are located under the table).
4. Align the table square to the rod by rotating the
table until the square and rod are in line.
5. Retighten table bevel lock.
6. Retighten set screw.
SCREW
BEVEL
LOCK
BEVEL SCALE
NOTE: The bevel scale has been included to provide
a quick method for beveling the table to approximate
angles. If precise accuracy is necessary, a square, or
other precision measuring tool should be used to posi-
tion the table.
1, To use the bevel scale do the following:
a. Loosensetscrewand tablebevel lock(see step
3 above).
b. Move table so desired angleor bevel scale is
straightacrossfrom zerolineontablesupport.
c. Retightentable bevel lock and set screw.
POINTER
SCALE
TABLE
|
TABLE
16
Loading ...
Loading ...
Loading ...