Loading ...
Loading ...
Loading ...
5
Locate center pulley assembly tn !oose parts bag
and place inproper hole
SPINDLE PULLEY
6. Locate two (2) V-belts in the loose parts bag.
7. Use speed chart inside belt guard to Choose speed
fordrilling operation. Install belts in correct position
for desired speed. The longer of the two belts is
always positioned between the spindle pulley and
idler pulley,
NOTE: Refer to chart inside belt guard for Recom-
mended Drilling Speeds.
8. Apply tension to belt by turning Belt Tension Handle
counter clockwise until belt deflects approximately
1/2 inch by thumb pressure at its center.
9. Tighten Belt Tension Lock Handles.
CAUTION: Over tensioning belt may cause motor not
to start or damage bearings.
10..If belt slips while drilling, readjust belt tension,
IDLER PULLEY
BELT
TENSION
LOCK
HANDLE
TENSION
HANDLE
BELT GUARD KNOB
Smm DIA. x 12ram LONG
SCREW
BELT GUARD
PAN HD.
INSTALLING BELT GUARD KNOB
1. To attach belt guard knob, locate knob and 5mm
Dia. x 12mm long pan hd. screw in loose pads
bag, Install screw in hole located in guard and at-
tach knob turning until tight.
WARNING: TO AVOID POSSIBLE INJURY KEEP
GUARD IN PLACE AND IN PROPER WORKING
ORDER WHILE OPERATING.
BELT GUARD,
13
Loading ...
Loading ...
Loading ...