Loading ...
Loading ...
Loading ...
POSITIONING TABLE AND WORKPIECE
Lock the table to the column in a position so that the
tip of the drill is just a little above the top of the work-
piece.
Always place a piece of BACK-UP MATERIAL (wood,
plywood...) on the table underneath the workpiece.
This will prevent "splintering" or making a heavy burr
on the underside of the workpiece as the drill breaks
through. To keep the backup material from spinning
out of control, it must contact the left side of the column.
as illustrated.
WARNING: TO PREVENTTHE WORKPIECE OR THE
BACKUP MATERIAL FROM BEING TORN FROM
YOUR HAND WHILE DRILLING, POSITION THEM
AGAINST THE LEFT SIDE OF THE COLUMN. IF THE
WORKPICE OR THE BACKUP MATERIAL ARE NOT
LONG ENOUGH TO REACH THE COLUMN, CLAMP
THEM TO THE TABLE. FAILURE TO DO THIS
COULD RESULT IN PERSONAL INJURY.
WORKPIECE
BACK-UP
MATERIAL
•_= <=
_L
For small pieces that cannot be clamped to the table,
use a drill press vise (Optional accessory.)
WARNING: THE VISE MUST BE CLAMPED OR
BOLTED TO THE TABLE TO AVOID INJURY FROM
SPINNING WORK AND VISE OR TOOL BREAKAGE.
WORKPIECE
DRILL PRESS
VISE
BOLT OR CLAMP
VICE SECURELY
4
Loading ...
Loading ...
Loading ...