Loading ...
Loading ...
Loading ...
...........................................,,,,,i?,?_I;,L'_I_,:_??+_;,i?,+i';L,,,;,i,:;,'',,+,+........ r.......................................................
___P' (_'too| is rece|vedas_embJed, repeat all steps in thissecthm to be sure assembly is_
and is m_ijusted for the operator.)
This Operator's Manual has been developed to help you
assemble the tool and to provide its safe operation, It is
important thai you read the entire manual to become
familiar with the tool below you begin assembly
a+ Flathead Screwdriver+
b. 1-1/4inch wrench or adjustable wrench+
c, Hex Wrench provided with tool+
.............3,','.......
B, AS._EMBLY S_PS
1. D[_IVE $_ HOUSING -- Figure 1
a o Place the two Screws (from the loose parts bag) into
the holes on the Clutch Shroud as shown in Figure I
b, Position the Lock-Nuts (from the loose parts bag)
in the hex openings in the Clutch Shroud,
c, Tighten theScrewswith the smatl hexwrench provid -
ed just enough to hold the hardware together while
holding the Lock-Nuts with your other hand,,
NOTE: Dirt on the Shaft will significantly reduce
the life of the tool, Ifrthe Flexible Drive Shaft falls
out of the Housing, clean, telube, then reinstall,
See "Flexible Drive Shaft Lubrication" in the
Maintenance section
d Remove the shipping cap fl'om the straight end
of the Drive Shaft Housing, Make sure the Flex-
ible Drive Shaft does not fall out of the Drive Shaft
Housing,
e Align the bottom groove on the Drive Shaft Hous-
ingwiththe Ridge on theinner, lowerwallof the
Clutch Shroud opening, Turn the Arbor Shaft as
necessary to align the square end of the Flexible
Drive Shaft with the square inside the Clutch
Shroud opening+ Firmly push the Drive Shaft
Housing into the Clutch Shroud until it contacts the
Foam Grip or is within I/8 inch+ Figure 1.
f. Tighten the Screws alternately with the small hex
wrench until secure.
CLUTCH
SHROUD
' RIDGE
DRIVE SHAFI
HOUSING
GROOVE
+ I
I I
I t
®
Loading ...
Loading ...
Loading ...