Loading ...
Loading ...
Loading ...
TRANSAXLE GEAR SHIFT LEVER NEU-
TRAL ADJUSTMENT
The transaxte should be in neutral when the
gear shift lover ts in neutral (N) (lock gate)
position. The adjustment _s preset at the
factory, however, if adjustment is needed,
proceed as follows:
1. Make sure transaxle is tn neutral (N).
NOTE: When the tractor rear wheels move
freely, the transaxie ts in neutral.
2, Loosen adjustment bolt in front of the
right rear wheel.
3, Position the gear shift lever _nthe neutral
(N) position.
4. Tighten adjustment bolt securely.
NOTE: If additional clearance _sneeded to
get to adjustment bolt, move mower deck
hetght to the lowest position,
Gearshift Adjustment Bolt
Lever ..- _ __
2_:., 5:-
Lock Gate
TO REMOVE WHEEL
1. Block up axle securely.
2. Remove axte cover, retaining ring and
washers to atlow wheel removal Irear
wheels have a square key - Do not tose)
3. Repair tire and reassemble,
NOTE: On rear wheels only. ahgn grooves in
rear wheel hub and axle, Insert square key.
4. Replacewashers andsnap retaining ring
securely _naxle groove.
5. Replace axle cover.
NOTE: To seal fire punctures and prevent
flat tires due to slow leaks, purchase and
use ttre sealant from Sears. T_resealant atso
prevents tire dry rot and corrosion.
Washers
Retaining
Axle Ring.
Cover\ \
'\
'\\
Square
(Rear Wheel Only)
FRONT WHEEL TOE-IN/CAMBER
Your new tractor front wheel toe-in and
camber is set at the factory and _snormal.
The front wheet toe-in and camber are Rot
adjus[able. If damage has occurred to
affect the factory set front wheel toe-in or
camber, contact a Sears or other qualified
service center.
TO START ENGINE WITH A WEAK BAT-
TERY
_WARNING: Lead-acid batteries gener-
ate explosive gases. Keep sparks, flame
and smoking materials away from batteries.
Always wear eye protection when around
batteries.
If your battery _stoo weak to star_ the engine,
it should be recharged. (See "BATTERY" in
the MAINTENANCE section of this manual).
If "jumper cables" are used for emergency
starting, follow th_s procedure
IMPORTANT' Your tractor is equipped with
a 12 volt system. The other vehicle must also
be a 12 vott system, bo not use your tractor
battery to start other vehicles.
TO ATTACH JUMPER CABLES -
I. Connect one end of the RED cabIe to the
POSITIVE (+) terminal of each battery(A-
B), taking care not to short against tractor
chassis.
2, Connect one end of the BLACK cable
to the NEGATIVE (-) terminal (C) of fully
charged battery.
3. Connect the other end of the BLACK
cable (D) to good chassts ground, away
from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER
1 BLACK cable f{rst from chass{s and then
from the fully charged battery,
2. RED cable last from both batteries,
A +A
Weak or Dead Fully Charged
Battery Battery
25
Loading ...
Loading ...
Loading ...