Loading ...
Loading ...
Loading ...
TO LEVEL MOWER
Ensure tires are properiy inflated to the PSi
shown on tires, if ttres are over or under
inflated, itmay affect the appearance of your
lawn and Iead you to th_nk the mower is not
adjusted properly.
VISUAL SIDE-TO-SIDE ADJUSTMENT
1. W_th all tires properly _nflated and ffyour
lawn appears unevenly cut, determine
which side of mower is cutting lower.
2. W_th a 3/4" or adjustable wrench, turn
lift link adjustment nut (A) to the left to
lower LH side of mower, or, to the right
to raise LH side of mower.
Turn nut Turn nut
rsght to left to
raise _ lower
mower mower
NOTE: Each full turn of adjustment nut w_ll
change mower height about 3/16" (4,7 ram).
3. Test your adjustment by mowing some
uncut grass and visually ci_eckmg the
appearance. Readjust, if necessary, untif
you are sat{stied with the resuits.
PRECISION SIDE-TO-SIDE ADJUSTMENT
1. Wtth all ttres properly inflated, park tractor
on level ground or driveway.
A01LCAUTION: Blades are sharp. Protect
your hands w_th gloves and/or wrap blade
w_th heavy cloth
2. Raise mower to its highest posit_on.
3. At both sides of mower, posltLon blade
at side and measure d_stance "A" from
bottom edge of blade to ground. The dis-
tance should be the same en both sides.
4. If adjustment _snecessary, see steps in
V_sual Adiustment instructions above.
5. Recheckmeasurements, adjustifneces-
sary until both sides are equal.
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-
to-side.
To obtain the best cutting results, the mower
blades should be adjusted so the front tip
is 1i8 to 1/2" (3,1 to t2,7 ram) (iower than
the rear tip when the mower Is in its h_ghest
posibon.
A(_CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap blade
w_th heavy cloth.
• Raise mower to h_ghest position.
• Position any blade so the tip is pointing
straight forward. Measure distance "B'Lto
the ground at front and rear hp of blade
• If front tip of blade is not 1/8 to I/2" (3,1
to ! 2,7 ram) lower than the rear tip, go to
the front of tractor.
• With an 11/16" or adjustable wrench,
loosen jam nut "A" several turns to clear
adjustment nut "B".
• With a 3/4" or adjustable wrench, turn
fro nt link adjustment nut "B" clockwise (,_)
(t_ghten) to raise the front of mower_ or.
counterclockwise (¢',) (loosen) to lower
the front mower.
®
T_grtten adjust Loosen adjust
nut "B" to nut "B" to
-- --- lower mower
raise mower
Loosen jam nut "A" first
NOTE: Each full turn of adiustment nut will
change mower height about 1,._8'' [3,1 mm).
• Recheck measurements, adjust if neces-
sary until front tip of blade is 1/8 to ti2"
(3,1 to I2,7 ram) lower than the rear tip.
• Hotd adjustment nut in positBon w_th
wrench and tighten jam nut securely
against adjustment nut.
23
Loading ...
Loading ...
Loading ...