Loading ...
Loading ...
Loading ...
TO REPLACE MOWER BLADE DRIVE
BELT
The mower blade drwe belt may be replaced
w_thout teoJs. Park the tractor on level sur-
face. Engage parking brake.
BELT REMOVAL -
1. Remove mower from tractor (See "TO
REMOVE MOWER" in this section of
manual).
2. Work belt off both mandrel pulleys and
idler pulleys,
3. Pull belt away from mower,
BELT INSTALLATION -
l. Work belt around both mandrel pulleys
and idler pulleys
2, Ensure belt _s in all pulley grooves and
inside all belt guides.
3, Instal! mower (See "To Install Mower" in
this section of this manual),
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parF,mg brake. For assistance, there is a
belt mstallabon guide decal on bottom s_de
of {eft footrest.
BELT REMOVAL-
1. Remove mower (See '%O REMOVE
MOWER 'r In this section of manual).
NOTE: Observe enbre motion dove belt
and position of all belt guides and keepers.
2. Remove beltfromstationary idler (A) and
clutching idler CB).
3. Pull belt slack toward rear of tractor.
Remove belt upwards from transaxle
toput pulley (D),
4. Remove belt downward from engine
pulley (E).
5. Shde belt toward rear of trac_or, off the
steering plate (F) and remove from tractor.
TO CHECK BRAKE
tf tractor requires more than five (5) feet (1,5
m) to stop at highest speed m h_ghest gear
on a level, dry concrete or paved surface,
then brake must be serviced.
You may also check brake by
1. Park tractor on a level, dry concrete or
paved surface, depress clutch/brake
pedal all the way down and engage
parking brake
2. Place gear shift lever _nneutral posEbon.
The rear wheels must lock and skid when
you try to manually push the tractor forward.
If the rear wheels rotate, then t_qe brake
needs to be serviced. Contact a Sears or
other quahfJed service center,
BELT INSTALLATION -
1. Install new belt from tractor rear to front,
over the steering plate (F) and above
clutch brake pedal shaft (G).
2. Pull belt toward front of tractor and roll
belt onto engine pulley (E).
3. Pull belt toward rear of tractor. Carefully
work belt down around transaxle input
pulley (D), Ensure belt is reside the belt
keeper.
4. install belt through stabonary idier (A_
and ctutchmg idler (B).
5. Ensure belt is _nall pulley grooves and
inside all belt guides and keepers.
6. Install mower (See "TO INSTALL MOW-
ER" In this secbon of manual),
24
Loading ...
Loading ...
Loading ...