Loading ...
Loading ...
Loading ...
AssemblingYour 4/Quart Mixer
OFF ON
TO ATTACH BOWL
1. Be sure speed control is OFF and
mixer is unplugged.
2. Tilt motor head back.
3. Place bowl on bowl clamping plate.
4. Turn bowl gently in clockwise
direction.
,5.Plug mixer in proper electrical outlet.**
TO REMOVE BOWL
1.Be sure speed control is OFFand
mixer is unplugged.
2. Tilt motor head back.
3. Turn howl in counterclockwise
direction.
Injury Hazard
Unplug mixer before inserting
or removing beaters.
Unplug mixer before cleaning.
Failure to do so can result in
broken bones or cuts.
4. Turn beater to
right, hooking
beater over pin
on shaft.
5. Plug mixer in proper electrical outlet.**
TO REMOVE FLAT BEATER,
WIRE WHIP OR DOUGH HOOK
1. Turn speed control to OFFand
tlnplug.
2. Press beater upward as far as
possible and ttlrn left.
3. Pull beater fi'ombeater shaft.
4. Plug mixer in proper elecnical outlet.*_
TOLOCKMOTORHEAD
1. Make sure motor head is completely
down.
2. Place locking lever in LOCK
position.
3. Before mixing, test lock by
attempting to raise head.
TO UNLOCKMOTORHEAD
1. Place lever in UNLOCKposition.
NOTE:Motor head should always
be kept in LOCK position when
using mixer.
TO ATTACHFLATBEATER,
WIREWHIP, OR DOUGHHOOK
1.Turnspeed control to OFFand
unplug.
2. Raise inotor head.
3. Slip heater onto heater shaft and
press upward as far as possible.
** See page 6.
11
TO OPERATE SPEED CONTROL
Plug mixer in proper electrical outlet.**
Speed control lever should always be set
on lowestspeed for starting, then
gradually moved to desired higher speed
to avoid splashing ingedients out ofbowl.
See page 14forSpeed ControlGuide.
Loading ...
Loading ...
Loading ...