Loading ...
Loading ...
Loading ...
Adjusting Temperature
Control Knob
The temperature in the oven has been set at the factory. When first
using the oven, be sure to follow recipe times and temperatures.
Then, if you think the oven should be hotter or cooler, the tem-
perature control knob can be adjusted. Before adjusting the knob,
test a recipe by using a temperature 25 °F higher or lower than the
temperature recommended. The baking results should help you to
decide how much of an adjustment is needed. The knob can be ad-
justed up to 50 °F hotter or 50 °F coole-_, in steps of 25 °F.
To adjust the temperature control knob
1. With the temperature control in the "OFF" position, pull the knob
straight off the shaft.
2. Look at the back of the knob. There are five small indicator lines
next to the screw. The center line indicates the original factory
setting, and the screw is located directly on that line.
3. Using a screwdriver, loosen the two screws about one turn each.
4. To increase or decrease the temperature, hold the knob "A" and
turn the knob skirt "B", moving the indicator screw closer to
"HOTTER" or "COOLER". Each notch increases or decreases
the temperature 25 °F. The screw will click into place on each
notch as the knob skirt is turned.
5. When you reach the desired adjustment, tighten both screws.
6. To replace the temperature control knob, line up the fiat sides
of both the knob and the shaft. Then push the knob into place.
NOTE: Once an adjustment is made, the "OFF" position will vary
from the reference mark on the backguard depending on the am_ount
of adjustment.
Examples of use:
After following recipe instructions for baking a cake, you have decided
the oven is 25 o too cool; proceed as follows:
1. Remove temperature knob from range.
2. Loosen both screws on the knob back.
3. Since you have determined your oven is cooking too cool, you want
to increase the temperature.
4. Move the indicator.screw one notch toward "HOTTER" by turning
the knob skirt.
5. Tighten both screws, and replace knob back onto shaft.
Accessories
Accessories are available at extra charge from your Frigidaire dealer
or Frigidaire Authorized Service Agency.
Frigidaire Surface Renewer. Order Part No. 9948629.
Side Panels for Slide-in Ranges. Order Part No. KAEPD.
Backguard for Slide-in Ranges_ Order Part No. BP-30D*0.
(a) (A)
21
Loading ...
Loading ...
Loading ...