Loading ...
Loading ...
Loading ...
10
Installation
WARNING: FUEL (GAS) BURNING RANGES MUST BE VENTED OUTDOORS USING, AT MINIMUM, METAL DUCTWORK
AND RANGE HOODS OF SUFFICIENT CAPACITY. Follow your fuel burning equipment manufacturer’s guidelines, as well as, all
applicable safety standards published by the National Fire Protection Association (NFPA), and the American Society for Heating,
Refrigeration and Air Conditioning Engineers (ASHRAE), and your local code authorities.
REMOVING THE ELECTRICAL KNOCK-
OUT HOLE
WARNING: Always wear safety goggles and
gloves during installation.
- Choose the appropriate electrical knock-out hole to remove
for your installation type. Use the top hole (1) if your
electrical supply is in the cabinet and the back hole (2) if
your electrical supply is on the wall below the cabinet (refer
to Fig. 10).
- Use a hammer and a athead screwdriver to gently punch
out the electrical knock-out hole.
REMOVING THE VENTING HOLE
(FOR EXTERIOR VENTING)
- Choose the venting hole to remove for your installation
type. Use the top holes (3 & 4) for a top venting installation
and the back hole (5) for a back venting installation.
- Carefully remove the cover (3, 4 or 5) of the appropriate
venting hole using a at head screwdriver or needle nose
pliers (refer Fig. 11). Be careful not to leave any debris
inside the range hood (A).
(FOR INTERIOR VENTING)
- If you are venting indoors, unscrew the 2 screws holding
cover (6) in place and remove the cover as per Fig.12. DO
NOT REMOVE ANY OTHER VENTING HOLE COVER.
1
2
A
Fig.10
1
A
Fig.11
3
4
6
A
Fig.12
INSTALLING THE DAMPER
(SKIP THIS STEP IF YOU ARE USING
INTERIOR VENTING)
Fig.13
E
7 7
C
BB
A
8
3
5
4
C
BB
A
3
8
BB
5
D
4
D
Fig.14
NOTE:
Only install the damper if you are using a venting system that does not
already have a damper. If this hood replaces an existing unit, the location
of the air exhaust can vary from one manufacturer to another. Ensure that
the damper ts in the existing opening before installing.
- The damper and the adapter are located inside the range
hood. To access these parts, remove the bottom panel (E)
if you have not previously done so (see Fig. 13).
- Choose to install the damper (C) either in the top
position (3) for top venting or in the back position (5)
for back venting. Adapter (D) installs to position 3 & 4 for
top venting only.
- Attach damper (C) or adapter (D) over chosen knockout
opening. Make sure the damper pivot is oriented on top
such that the damper stays closed when not in use.
- Secure the damper (C) or adapter (D) to the range hood
(A) with the short tapping screws (BB).
- Seal the damper (C) or adapter (D) to the range hood (A)
on all four sides with duct tape.
Loading ...
Loading ...
Loading ...