Loading ...
Loading ...
Loading ...
Installation and User Instructions R02889-3 04/14
Page 32
Operation
- Rotate the dial to select Set and
press the dial to select
- Rotate the dial to select Set Temp
and press the dial to select
- Press the dial to select Primary
Temp to set the primary immersion
temperature or rotate the dial to
Boost Temp and press the dial to
select the Boost temperature set
point
10.2.5 Activate and De-
activate the Boost
Immersion
This is accessed from the Home
screen and will be active until the
boost temperature is achieved:
- press the advance button to activate
- press the advance button again to
de-activate (see Figure 19)
10.2.6 Accessing Energy and
Temperature
Information
The Quantum cylinder also provides
information about the hot water
stored. Information is provided on
the current status of the cylinder as
well as some historical data. This
information is accessed by pressing
the selector dial for 3 seconds to
display the user information menu;
three choices are available:
1. Temperature – Displays the
current, minimum and maximum
temperatures recorded by the four
temperature sensors
2. Energy
i. Current – Displays current
energy consumption by the
immersion heater, storage
capacity is the remaining
storage capacity in the cylinder
at that moment of time and the
available hot water volume
relating to the set temperature
(stored now). Should the
temperature be higher than the
set temperature, then the
mixed water volume to the set
temperature is stated.
ii. History – gives the energy
consumption in kWh available
for day -1, week-1, month-1,
and the total energy that the
unit has consumed since it has
been installed.
The colour of the display will turn red
once 48 °C is exceeded.
Above this temperature is generally
considered to be unsafe and could
cause a serious scald. The user should
always run the cold tap first when
filling a bath and test the water before
getting into a bath or shower. The
recommended temperature for
bathing is 37°C.
3. Counter - Displays the total
number of hours logged utilising
the boost function.
10.2.7 Accessing and Setting
Timer Modes
To access and select Holiday Mode or
No Control, follow the steps below:
- Press the menu button
- Rotate the dial to select Timer
Mode and press the dial to select
- Rotate the dial to select one of
Holiday or No Control and press the
dial to select
- Set the desired timer conditions
and press the dial to confirm
Holiday mode disables all heating
during the selected holiday period.
The holiday period consists of the
Loading ...
Loading ...
Loading ...