WaterBoss PRO 180 OWNER’S MANUAL AND INSTALLATION GUIDE

Loading ...

WaterBoss Softener Two-Button Owner’s Manual 8/1/2018 15

Advanced Customer Settings

Most customers will want to use the factory default settings, so no changes are necessary. However, you can reset the

controller settings if the factory default settings are not suitable for your needs. If at any time you wish to change the units

to metric or restore the controller completely back to factory default settings, see Additional Features.

To Enter Advanced Customer Settings Mode

Press and hold the P and R



buttons at the same time for 3 seconds. The display should show only the controller type

18 (model Pro180) or 38 (model ProPlus380).

Step 1

Set Salt Setting

A. The S indicator will blink and the display reads (S1), designating the default of Salt Setting #1.

B. Press the R



button momentarily to cycle through the salt settings. There will be two available fixed

salt settings and the Automatic Salt Setting.

1. (S1) ensures that for each regeneration, the appliance gets at least 4000 grains per pound

(570 grams/kg) of salt. This choice meets or exceeds the requirements some states currently

have in regards to salt efficiency.

(S2) will provide more capacity between regenerations than S1.

(SA) is the automatic salt setting that uses the average daily water usage to determine an

appropriate salt dosage, not to exceed the appliance’s maximum capacity.

Note: This salt setting is recommended for large families and/or water with high levels of

hardness. It gives the greatest capacity, if needed.

C. When the desired setting is displayed, press the P button.

Note: All models are equipped with patented capacity guard to prevent the over-exhaustion of the

resin bed.

Step 2

Set Time of Day

A. The



indicator will blink and the display reads 00.

B. Press the R



button to cycle through values 00 to 23 representing the Time of Day on a

24-hour clock.

Note: Set time to the nearest hour.

C. When the desired setting is displayed, press the P button.

Note: Whenever you experience an electrical outage, check your controller for the correct time.

Make any necessary corrections.

Loading ...

WaterBoss PRO 180 Water Softener