Loading ...
Loading ...
Loading ...
WaterBoss Softener Two-Button Owner’s Manual 8/1/2018 13
Two-Button Controller, Cont.
Controller Part
Function
Indicator
Shows the controller settings and used to indicate status during programming.
Hd
Blinks when setting the water hardness value.
S
Blinks when choosing a salt setting. Options (S1), (S2), or (SA) will also display.
Blinks when setting Time of Day (24-hour clock).
& R
Both blink when setting Time of Regeneration (24-hour clock).
R
Blinks when setting Demand/Delayed mode. Blinks when Delayed mode is off (- -); remains lit when
Delayed mode is on ( ). When Delayed mode is off (- -), the appliance is in Demand mode.
96H
Blinks when setting 96-Hour mode. Blinks when 96-Hour mode is off (- -); remains lit when 96-Hour mode
is on ( ).
PC
Blinks when setting powerClean
TM
mode. Blinks when powerClean
TM
is off (- -); remains lit when
powerClean
TM
is on ( ).
Note: powerClean™ is a service/maintenance step for water supplies that have an excessive amount of
iron. In powerClean™ mode, each appliance will regenerate every other day with either 5 pounds (2.3 kg)
(model Pro180) of salt or 7 pounds (3.2 kg) (model ProPlus380) of salt. Leave the feature on for a
minimum of two weeks at a time, every six months, so that the frequent regenerations can eliminate iron
buildup in the resin bed. Salt with an iron cleaning agent or iron out cleaner is recommended for
continuous use as a preventive measure against iron fouling of the resin bed. Properly using this feature
and following these tips will help to ensure a long service life for your appliance.
Button
Function
P
Used to program and save Customer Settings.
R
Used to change Customer Setting values and to start an immediate regeneration (for example, to restore
capacity if you run out of salt).
To Start an Immediate Regeneration
1. Press and hold the R
button until the cycle begins.
2. The appliance is in regeneration mode and will display the status of each cycle (for example, 01).
3. After all regeneration cycles are complete, the display will return to Normal Operation.
To Quickly Advance Through the Regeneration Cycles
(used when starting up or diagnosing the appliance only)
1. Press and hold the R
button until the cycle begins.
2. The cycle position will display (for example, 01).
3. If the controller does not advance to the next cycle position after 20 seconds, press and hold the R
button until the cycle number changes (about 2 seconds).
Each cycle can be advanced by pressing the R
button. Always wait until the cycle position displays
before advancing to the next cycle position.
Loading ...
Loading ...
Loading ...