Loading ...
Loading ...
Loading ...
-
ASSEMBLY INSTRUCTIONS
ASSEMBLING AND INSTALLING MATERIAL WORK SUPPORTS
Figure 5
1. Slide one (13) M6*55 carriage bolt through the square hole in the (4) wide material support
and extend through the other side.
2. Place the (5) work stop over the end of the bolt.
3. Thread one (11) knob nut over the end of the bolt and tighten to secure.
4. Slide the wide material support rail through the hole in the top of the (6) material
support receiver.
5. Insert one (10) knob screw through the small hole on the side of the material support
receiver and tighten to secure.
6. Insert one (20) small screw into the bottom of the wide material support rail and tighten
to secure.
7. Slide the (6) material support receiver over the extension rail so that the extension rail
extends through the opening in the receiver. Position the work support at the desired
location on the extension rail.
8. Insert one (20) small screw into the back of the extension rail and tighten to secure.
9. Repeat with other supports.
FIG 5
Work Stop
Knob Nut
Material
Wide
Material
Support
Support
Receiver
Knob Screw
Knob Nut
Knob Nut
Knob Screw
Small Screw
Handle
Extension Rail
Small Screw
Page 7
Loading ...
Loading ...
Loading ...