Loading ...
Loading ...
Loading ...
-
~
-
ASSEMBLY INSTRUCTIONS
ATTACHING THE BUCKET HANGER
Figure 7
1. Place (28) bucket hanger hoop over the central tubing.
2. Feed (30) M5*47 bolt through cord snap then through the bucket hanger.
3. Apply (25) M5 Nylon nut and tighten.
FIG 7
M5*47 Screw
M5 Nylon Nut
Bucket Hanger
ATTACHING YOUR MITER SAW OR OTHER BENCHTOP POWER TOOL
Figure 8
Various bench top tools can be used with your Miter Saw Workstation by attaching them to the
Rapid Clamp Tool Mounts. Always position the saw to achieve maximum balance and stability.
All four corners of the saw must be bolted to the tool mounts before use. Make sure bolts do not
extend above the table of the miter saw.
1. Unplug the saw and lock the saw arm in the down position.
2. Place a tool mount underneath the saw, aligning the mounting holes on the miter saw base
with the slot in the top of the tool mount.
3. Feed one (16) M8*60 carriage bolt up through both the tool mount and a mounting hole in
the saw.
4. Secure in place using a (17) flat washer, (18) spring washer, and (15) M8 nut.
5. Repeat through the other end of the tool mount.
6. Place the second tool mount underneath the other side of the saw, aligning the mounting
holes on the miter saw base with the opening in the tool mount.
7. Install (16) M8*60 carriage bolts as previously described.
8. After making sure both tool mounts are parallel to each other, finger tighten all four nuts to
hold in position.
NOTE: If the saw has holes that do not line up with the slots in the tool mounts, use the
offset mounting brackets.
FIG 8
Page 9
Loading ...
Loading ...
Loading ...