Loading ...
Loading ...
Loading ...
-
- ~ ~ ( _
II . ( \
t
I)
ASSEMBLY INSTRUCTIONS
OFFSET MOUNTING
Figure 9
Offset mounting bracket for miter saws and/or power tools with an irregular mounting hole pattern.
Instructions: Secure (3) offset mounting brackets as shown using the supplied (16) M8*60
carriage bolts. These brackets can be used on the front or rear of the rapid clamp tool mounts to
accommodate your specific power tool.
FIG 9
Offset Mounting Brackets
ATTACHING CORD MINDER
Figure 10
1. Locate leg with 2 pass-through holes. (handle side)
2. Pass one (23) M5*55 screw through the top hole of the leg and through the (12) plastic cord
minder attachment, making sure that the tip of the cord minder attachment is pointing up
towards the top of the stand.
3. Apply (25) M5 nylon nut and tighten.
4. Pass one (23) M5*55 screw through the (22) cord clip then through the body and the plastic
cord minder attachment, making sure that the tip of the cord minder attachment is pointing
down towards the ground.
5. Apply (25) M5 nylon nut and tighten.
M5*55 Screw M5*55 Screw
FIG 10
Cord Clip
Cord Minder M5 Nylon Nut M5 Nylon Nut Cord Minder
Attachment Attachment
Page 10
Loading ...
Loading ...
Loading ...