Loading ...
Loading ...
Loading ...
20 EN
Radio
Listen to FM radio on your Blu-ray Surround
Base , and store up to 40 radio stations.
Note
AM and digital radio are not supported.
If no stereo signal is detected, you are prompted to
install the radio stations again.
1 Connect the FM antenna to FM
ANTENNA on your Blu-ray Surround
Base .
For the best reception, place the
antenna away from your TV or other
sources of radiation.
2 Press SOURCE repeatedly to select radio
source.
» If you have already installed the radio
stations, the last channel that you
listened to is played.
» If you have not installed any radio
stations, the message [AUTO
INSTALL...PRESS PLAY] appears on
the display panel. Press
to install
radio stations.
3 Use the remote control to select or to
change radio stations.
Play buttons
Button Action
/
or
Alphanumeric
buttons
Select a preset radio station.
Navigation
buttons
Left/Right: Search for a radio
station.
Up/Down: Fine tune a radio
frequency.
Press to stop the installation
of radio stations.
Press and hold to erase the
preset radio station.
Manual: 1) Press . 2) Press
/ to select your preset.
3) Press
again to store the
radio station.
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
SUBTITLE Toggle between the stereo
and mono sounds.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz.
1 Press SOURCE repeatedly to select radio
source.
2 Press .
3 Press and hold to toggle between 50
kHz or 100 kHz.
MP3 player
Connect a MP3 player to play audio les.
What you need
An MP3 player.
A 3.5mm stereo audio cable.
1 Using the 3.5mm stereo audio cable,
connect the MP3 player to the AUDIO IN
connector on your Blu-ray Surround Base .
If you use 6.5mm stereo audio cable,
connect the MP3 player to your Blu-
ray Surround Base using a 3.5mm -
6.5mm converter jack.
2 Press SOURCE repeatedly until [AUDIO
IN] appears in the display panel.
3 Press the buttons on the MP3 player to
select and play audio les.
Loading ...
Loading ...
Loading ...