Loading ...
Loading ...
Loading ...
English - 19
02 INSTALLING YOUR DRYER
Method 2
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old
hoses.
1. If the “Y” connector cannot be attached directly to the cold
water faucet, the short hose must be used.
2. Turn the cold water faucet o .
3. Attach the short inlet hose to the cold water faucet.
Screw on the coupling by hand until it is seated on the
faucet.
4. Using the pliers, tighten the coupling with an additional two-
thirds turn.
Do not overtighten, as this may damage the coupling.
5. Attach the ‘Y” connector to the brass male end of the small
hose. Screw on the coupling by hand until it is seated on the
connector.
6. Using the pliers, tighten the coupling with an additional two-
thirds turn.
Do not overtighten, as this may damage the coupling.
7. Attach the angled end of long hoses to the fi ll valve at the
bottom of the dryer rear frame. Screw on the coupling by
hand until it is seated on the fi ll valve connector.
8. Using pliers, tighten the coupling with an additional two-
thirds turn.
Do not overtighten, as this may damage the coupling.
9. Check that the water faucets are on.
10. Check for leaks around the “Y” connector, faucets and
hoses.
Short hose
(Inlet to cold
water)
“Y” connector
Long hose
Duct Exhaust
Frame
(back)
Water Hose
DV457E1_02836J-06_EN_140428.indd 19DV457E1_02836J-06_EN_140428.indd 19 2014-04-28 5:30:052014-04-28 5:30:05
Loading ...
Loading ...
Loading ...