Loading ...
Loading ...
Loading ...
Basic Operation
-37
Turning the Projector On/Off
Info
• English is the factory preset language. If you want to
change the on-screen display to another language,
change the language according to the procedure on
page 89.
▼On-screen Display
Info
•
Do not unplug the power cord during projection or cool-
ing fan operation. The cooling fan in this projector contin-
ues to run for about 90 seconds after the projector enters
the standby mode. This can cause damage due to rise in
internal temperature, as the cooling fan also stops.
Power cord
Supplied
accessory
Connecting the Power Cord
Plug the supplied power cord into the
AC socket on the rear of the projector.
Turning the Projector On
Before performing the steps in this section,
connect any equipment that you use with the
projector. (See pages 27—36.)
Remove the lens cap and press on the
projector or on the remote control.
• The power indicator illuminates green.
• After the lamp indicator illuminates, the projec-
tor is ready to start operation.
• When System Lock is set, the keycode input
screen appears. Enter the right keycode to
start projection. See page 79 for details.
Note
• The lamp indicator illuminates or blinks, in-
dicating the status of the lamp.
Green: The lamp is ready.
Blinking green: The lamp is warming up.
Red:
The lamp is shut down abnor-
mally or the lamp should be
replaced.
•
When switching on the projector, a slight flicker-
ing of the image may be experienced within the
first minute after the lamp has been illuminated.
This is normal operation as the lamp's control
circuitry is stabilizing the lamp output charac-
teristics. This does not indicate malfunction.
• If the projector is put into standby mode and
immediately turned on again, the lamp may
take some time to illuminate.
Turning the Power Off
(Put-
ting the Projector into Standby Mode)
1 Press
on the projector or
on the remote control, then
press that button again while the
confirmation message is dis-
played, to put the projector into
standby mode.
2
Unplug the power cord from the AC
outlet after the cooling fan stops.
Power cord
Side view
To AC socket
Lamp indicators 1, 2
Power indicatorSTANDBY
button
ON button
Lens cap
ON button
STANDBY
button
Loading ...
Loading ...
Loading ...