Loading ...
Loading ...
Loading ...
7
4. Remove hairpin clip (P) and clevis pin (O) from the
coupling in motor housing (F). Retain for later use.
Loosen the two coupling screws (Q), but do not
remove them.
Note: Make sure to keep loose hardware separate to
avoid confusion during installation.
For STANDARD/ANGLE-MOUNTING
INSTRUCTIONS, proceed to step 1 below.
For FLUSHMOUNT INSTRUCTIONS, skip to page 8.
1. Insert downrod assembly (B) through canopy (C),
canopy cover (D) and coupling cover (E).
2. Feed power wires from motor housing (F) through
(B) into the coupling on motor housing (F).
INITIAL INSTALLATION INSTRUCTIONS
STANDARD/ANGLE-MOUNTING INSTRUCTIONS
F
O
P
Coupling
Q
4
Note: Motor wires have been
omitted from diagram.
D
C
E
B
1
Lowes.com/harborbreeze
WARNING: Ensure all screws are tight before
moving on to the next step.
2
F
B
P
O
Q
Coupling
downrod assembly (B), then insert downrod assembly
Align the hole on downrod assembly (B) to the hole on
the
coupling, then re-install clevis pin (O). Re-attach
hairpin clip (P) into clevis pin (O) until it snaps into
place, then tighten the two previously loosened
coupling screws (Q).
Loading ...
Loading ...
Loading ...