Loading ...
Loading ...
Loading ...
10
1. To sync the remote from power kit (M) to the receiver
also in power kit (M),
remove the battery
cover from the remote and slide code switches to
your choice of up or down position using a small
screwdriver or ballpoint pen (neither included).
Note: The factory setting for the code switches is
all up; do not use this position.
WIRING INSTRUCTIONS
WARNING: To avoid possible electrical shock, be sure electricity is turned off at the main fuse
box before hanging.
WARNING: If house wires are of different colors than referred to in the following steps, stop
immediately. A professional electrician is recommended to determine proper wiring.
Note: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it
must be grounded for safe operation.
Note: The remote from power kit (M) has 16 different code combinations. To prevent possible
interference from or to other remote units, simply change the combination code in your remote and
receiver as described in Step 1 below.
ON
1 2 3 4
DIP
DIP
ON
1
Remote
Receiver
Lowes.com/harborbreeze
2. Slide the receiver from the power kit (M) into the open
end of the mounting bracket (A) with the
side of
the receiver facing the ceiling.
A
Receiver
2
Slide the code switches on the receiver to the same
positions, then replace battery cover on the remote.
Loading ...
Loading ...
Loading ...